New products

Traxxas

Gear set, 2-speed wide ratio (2nd speed gear 38T, 13T-18T input gears, hardware)

Traxxas

Primary shaft/ 1st speed hub/ one-way bearing/ snap ring/ 5x8mm TW

Traxxas

OptiDrive electronic shift module

Traxxas

Wing mount, center / wing washers (for Revo)

Traxxas

Ultra Shocks (black) (short) (complete w/ spring preload spacers & springs) (2)

Traxxas

Housing, diff & cover (f)/ shock tower (f)

Traxxas

Rear body mount base/ rear body mounting posts (2)/rear body mounting clamps (4)/ screws

Traxxas

Spur gear, 38-tooth (1.0 metric pitch)

Traxxas

Shoulder screws, 3x10mm (6) (with threadlock)

Traxxas

Clutch bell, (20-tooth)/ 5x8x0.5mm fiber washer (2)/ 5mm E-clip (requires #4611-ball bearings, 5x11x4mm (2)

Traxxas

Caster wedges, reactive (2)

Traxxas

Suspension arm upper (1)/ suspension arm lower (1) (rear, left or right)

Traxxas

Adjustable Wheelbase Suspension Arm Set

Traxxas

Toe link, 5.0mm steel (front or rear) (2)

Traxxas

Header, exhaust (tubular aluminum, silver-anodized)/ spring mount (TRX 2.5, 2.5R 3.3)

Traxxas

Rod ends, Revo (large, for rear toe link only) (4)

Traxxas

Linkage, steering (Revo 3.3) (3x50mm Turnbuckle) (2)/ rod ends (short) (4)/ hollow balls (4) (for use with Revo extended wheelbase chassis)

Traxxas

Bulkhead, front (L&R halves)/ diff retainer/ 4x14mm BCS (4)

Traxxas

Steering blocks/ axle housings (L&R) w/ metal inserts(3x4.5x5.5mm) (2)

Traxxas

Screws, 4x12mm button-head machine

Traxxas

Bulkhead cross braces (2)/ 3x25mm CS screws (8)

Traxxas

Crankshaft, IPS (for engines w/starter) (TRX 3.3)

Traxxas

Roll hoop, plastic/ transmission skid guard, plastic

Traxxas

Bulkhead, rear (L&R halves)/ diff retainer, rear/ 4x14mm BCS (2)

Traxxas

Servo mounts, steering (2)

Traxxas

Shoulder screws, steering bellcranks (3x30mm cap-head machine) (2)/ draglink shoulder screws (chrome) (2)

Traxxas

Box, receiver & battery (2)/ cover/ foam pad & adhesive/ charge jack plug (rubber)/ 4x8mm BCS (1)/ 4x12mm BCS (2) (contains both boxes to accommodate either AA battery holder or RX flat pack)

Traxxas

Header, blue-anodized aluminum (for rear exhaust engines only) (TRX 2.5, 2.5R, 3.3)

Traxxas

Hold downs, battery, left & right (2)/ foam spacers (2) (fits standard battery packs)

Traxxas

Push rod (aluminum) (assembled with rod ends) (2) (red) (use with #5359 progressive 3 rockers)

Traxxas

Wheelie bar mount (1)/ hardware (black). Use Part #4974 and 4976 to complete the wheelie bar assembly.

Traxxas

Caster blocks (L&R) (30-degree)

Traxxas

Series Y-harness with Traxxas High Current Connectors

Traxxas

Wiring harness for RX Power Pack, Revo (includes on/off switch and charge jack)

Traxxas

Stub axle pins (4)

Traxxas

Shock shafts, steel, chrome finish (xx-long) (2)

Traxxas

Fuel line (1 foot)

Traxxas

Bumper, rear (T6 aluminum)

Traxxas

Battery holder, 4-cell/ on-off switch

Traxxas

Air filter housing/ foam insert/ Revo-Slayer air filter base (angled)/ cable tie (1-each) (TRX 2.5, 2.5R)

Traxxas

Air filter body (high-volume)/ filter support/ cap/ foam filter, pre-filter/ T-Maxx filter base (angled)/wire mount/hardware (1 each) (Fits Maxx trucks) (TRX 2.5, 2.5R, 3.3)

Traxxas

Housing set (inner, outer)/ 3x12mmBCS (5)/ 3x20BCS (1)/ engine bushing (EZ-Start 2)

Traxxas

Backplate/ 20x1.4mm O-ring (for engines with starter) (TRX 2.5, 2.5R)

Traxxas

Engine/ pinion gear/ engine bushing (EZ-Start 2)

Traxxas

Air filter housing/ foam insert/ straight base/ angled base/ cable tie (1-each) (TRX 2.5, 2.5R, 3.3)

Traxxas

Servo case/gaskets (for 2056 and 2075 waterproof servos)

Traxxas

Waterproof Sub-Micro Servo

Traxxas

Waterproof Digital Micro Servo

Traxxas

Bulkhead (front) (grey)

Traxxas

Pipe coupler, molded (for use with pipes 5152 (T-Maxx) & 4452R) (TRX 2.5, 2.5R, 3.3)